Customers who purchased this item also purchased:

Mild Steel Weld Fitting for O2 Sensor, 45 Degree Angled

Stainless Weld Bung for O2 Sensor, 1 Inch Long with Plug

AN Plastic Flare Cap (threaded, not push-on type)

Mild Steel Weld Fitting for O2 Sensor, 1/2" Reach w/Plug

Stainless O2 Sensor Blanking Plug, 18 x 1.5mm

What our customers are saying:

"Subject: Service quality. You guys are sooooooo much better than the competition! Thanks."
J.W. from California

Mild Steel Weld Bung for O2 Sensor, 1" Reach w/Plug

Weld this mild steel fitting into your exhaust to mount any oxygen sensor with the standard 18x1.5mm thread. The extended 1 inch depth is designed to back the O2 sensor out of the exhaust pipe for situations where a standard short bung results in restricted exhaust flow or an overheated sensor.

Sold individually. Sensor sold separately. The included threaded plug lets you seal off the bung if you run without a sensor installed.

We also offer an Extended 1" Reach O2 Sensor Weld Bung in Stainless Steel (Part No. 3878-3838).

Qty

Part No.

Price

Stock Status

3878-3764

Condition: New

$11.49

In Stock

Customers who purchased this item also purchased
Mild Steel Weld Fitting for O2 Sensor, 45 Degree Angled	Stainless Weld Bung for O2 Sensor, 1 Inch Long with Plug	AN Plastic Flare Cap (threaded, not push-on type)	Mild Steel Weld Fitting for O2 Sensor, 1/2" Reach w/Plug	Stainless O2 Sensor Blanking Plug, 18 x 1.5mm

Mild Steel Weld Bung for O2 Sensor, 1" Reach w/Plug

Qty

Part No.

Price

Stock Status

3878-3764

$11.49

Customers who purchased this item also purchased

Related Product Groups

Auto Meter Wideband Air/Fuel Ratio Monitors

Female Threaded Weld Bungs and Male Threaded Weld Fittings

Innovate Wideband Air/Fuel Ratio Monitors

Oxygen Sensor Weld Bungs and Fittings