3/4 x 1 inch Wear Strip, per inch of length

If your chassis, side pod or air dam suffers damage from occasional bottoming out, you'll probably want to let these economical wear strips take the punishment. In one test, this special highly abrasion resistant polymer outlasted stainless steel more than 5 times! It is easily drilled, tapped or machined much like aluminum except the cutting speeds can be much higher. Sold per inch; specify length in inches.

If any length is 60 inches or greater, your order will require an additional handling surcharge. We can cut down a long strip into 2 or 3 short pieces for no extra charge to avoid excess shipping costs. Just note in Special Instructions if you'd like the piece cut or in one continuous length.

One inch wide strips are standard but we also offer custom-cut rectangular Chassis Wear Plates (Part No. 6107) to your specifications.