FIA Rated Roll Bar Padding has been proven to lessen impact forces transmitted to the head. It is specifically recommended for use in areas where the helmet may contact the tubing.*
This half-round "C" shape covers one side of a tube between 1 1/8" and 1 5/8" diameter (28mm to 42mm). The inside surface is lined with a peel-and-stick adhesive. We recommend backing up this adhesive with a few zip ties. Two pieces are shown in photo to illustrate inside and outside of padding. Approximately 1 1/8" thick in the center and 1/2" thick at the edges. The outer face is flat to better manage impact energy. 36 inch sections available in Black only. Meets FIA 8857-2001 Type A specifications.
We also offer larger FIA Rated Roll Bar Padding for 1 3/4 - 2.0 Inch Diameter Tubing, Part No. 2399.
* Note: FIA-rated foam padding is designed for installation between the helmet and the roll bar. This padding is extremely stiff and rigid. It does not give except in very hard impacts. It is intended to cover only one side of the bar (the side between the bar and your helmet).
All other areas of the roll cage should be padded using softer High-Density Roll Bar Padding, Part No. 2390.
