Brand: Induction Technology Group
You want to run an ITG filter assembly on your velocity-stack-equipped intake, but there's an issue with mounting it right to the face of the intake. Whether it's a clearance issue with a throttle linkage, the mounting face isn't flat, or you just don't want to drill a dozen bolt holes in the base plate, air horn grommets may be the answer!
This rubber grommet is designed to be installed in an 89mm (3 1/2") ID hole in your base plate. The grommet ID stretches to accommodate an air horn measuring 60mm to 64mm (2 3/8" to 2 1/2") OD. Drill your base plate, install the grommet, push your air horn through the grommet, and install on your intake. No fasteners needed. Sold individually, each fits one air horn. Air horns, base plates, etc are all sold separately.
Note: Fits most 60mm OD sleeve-mounted air horns. Does not fit air horns with a bolt-on flange.
