This pulley will fit current Formula Ford 1600 (Kent) and FF2000 / Sports 2000 (Pinto) mechanical water pumps. Some older pumps had 1/2 inch diameter shafts and require a different pulley with a smaller bore, or the fabrication of an adapter sleeve or bushing.
The 44 tooth size is normally mated with our 30 Tooth 1.6L Crankshaft Pulley (Part No. 166-30) on the 1600 or the 38 Tooth 2.0L Crankshaft Pulley (Part No. 176-03) on the 2.0L. This results in a 1.47:1 underdrive ratio on the 1600 and 1.16:1 underdrive on the 2.0L engine.
This cast aluminum pulley measures approximately 2 3/4" diameter, with a deep setback to minimize the cantilevered load on the water pump bearings.
Crankshaft pulley and XL drive belt are sold separately:
FF1600 engines should use the FF1600 Crankshaft 30 Tooth Water Pump Pulley (Part No. 166-03) and the 180XL050 Water Pump Drive Belt (Part No. 166-01-180).
2.0L Pinto engines should use the 2.0L Crankshaft 38 Tooth Water Pump Pulley (Part No. 176-03) with the 190XL050 Water Pump Drive Belt (Part No. 166-01-190).
