This nylon bushing helps to seal each end of the throttle shafts on the 32/36 DGV carburetor and control throttle shaft thrust (end play). Side loading of the shafts due to pulling by the throttle cable or linkage can wear this bushing and cause vacuum leaks or a sticking throttle. Four bushings are required per carburetor (two per throttle shaft). Sold individually.
Note: This bushing does not support the throttle shaft in the carburetor body. If the throttle shaft bore in the carburetor body is worn, two of the bushings (at the cable/linkage end) should be replaced with our Weber DGV Throttle Shaft Bearing Kit, Part No. 1579-001.
