Brand: AIM Sports
This 2000 psi pressure sensor is ideal for measuring brake pressure (or any other pressures too high for a 300 psi sensor).
KA pressure sensors are more robust than the old VDO-style pressure sensors, but all sensors should still be isolated from engine heat and vibration whenever possible. It is compatible with all AiM MX-Series dashes, EVO3/EVO4/EVO5 loggers, CAN Channel Expansion Hub, and the MyChron Expansion. 1/8 NPT male threads. Body design may vary from photo. Sold individually.
It can be easily installed in your 3AN brake hose by adding our Tee Fitting with 1/8 NPT Female Branch and -3 Hose Ends (Part No. MC-344, sold separately), or between your 3AN hose end and male 3AN fitting using our 3AN Male to 3AN Female Swivel with 1/8 NPT Female Branch (Part No. AF140-03-SS, sold separately).
This sensor has a 50cm (19.68") long cable with a 719 (four-pin plastic push-on type) connector permanently attached. Use a My Chron 719-719 Patch Cable (Part No. MC-211) to connect to any AiM MX-Series dash or EVO3/EVO5 logger. EVO4/EVO4S, CAN Channel Expansion Hub, and MyChron Expansion require a 712-719 Patch Cable (Part No. MC-210, sold separately).
Note: This sensor requires a "+Vb" (battery voltage) power supply, not the traditional "Vref" (5V reference signal) used by older sensors. Current MX-Series dashes, EVO4 and later loggers, MyChron Expansion, and CAN Channel Expansion Hubs have the +Vb supply available on all analog channels. MyChron3 and older dashes do not have the necessary +Vb supply on any channel. MXL Pista and EVO3 Pista only have +Vb on Channels 4 through 8. MXL Pro and EVO3 Pro only have +Vb on Channels 8 through 11.
