ITG "Stubby" Bolt-On Radiused Inlet for 45 DCOE, 13mm High

Brand: Induction Technology Group

Are you so squeezed for space that you can't even fit our super-low velocity stacks on your Weber 45 DCOE? These ultra-low "stubby" stacks add just 13mm (1/2") to the front of your carb!

The bolt-on design eliminates the air horn mounting tabs. The stack can be mounted under an air filter base plate, allowing the use of a very low-profile filter. The 65mm mounting bolt spacing fits Weber 45 DCOE*; Dellorto 45 DHLA; SK 45 50 DBS; Mikuni 44 PHH, and Solex 45 DHH carburetors . Sold individually.

Note: Not recommended for later Weber 45 DCO/SP. This airhorn design does not extend into the carburetor throat and will not retain the short auxiliary venturi on the 45 DCO/SP.