Brand: Totim Racing
| This item qualifies for FREE Shipping in the continental United States! |
Totim Racing has revolutionized how custom-fit racing seat inserts are made! These unique kits are fully sealed (no measuring and no mess) inside an FIA fire-resistant bag (no additional covering required) and can be fitted in as little as 30 minutes with no other tools required. You don't even need a helper!
Each kit consists of pre-packaged, pre-measured 2-part polyurethane that expands when mixed. You never touch the chemicals! Just break the seal between the two portions and knead the bag until the expanding foam causes the inner pouch to pop (about 50 seconds). Put the bag in the car and let it expand for another 40-50 seconds. Finally, put the driver in the car and let the bag expand to fit the driver (15 to 20 minutes, depending on kit size). The insert is ready for use or trimming after 40 minutes of cure time. You could make your custom-fitted insert start to finish during the lunch break!
The T3092 Series uses the largest bag which measures 140cm x 100cm (55" x 39 3/8"). This is large enough to make a full-length, wrap-around seat with lateral leg support in most LMP3, LMP4, F2, F3, Super Formula, Formula Renault, and IndyCar.
Size M contains 2.3kg of foam to suit large drivers.
Size L contains 2.7kg of foam to fit small and medium drivers.
When in doubt, choose the larger kit! It is easy to trim off excess material from an insert, but it is not possible to add material to an insert.
