Brand: Facet-Purolator
For moderate fuel requirements of engines up to about 150 horsepower, a single Solid State fuel pump like this one is usually sufficient. Facet fuel pumps have low power requirements (about 1 amp at 12 volts) and operate without troublesome seals or diaphragms. Built-in pressure relief means no flooding after shutting down a hot engine. Facet pumps are compatible with gasoline, alcohol blends (up to and including E85), diesel, biodiesel, and fuel additives.
Maximum fuel delivery 32 gallons per hour. Maximum pressure 4.5 to 6 psi. Typical flow 15 gallons per hour at 3 psi. 1/8 NPT female ports.
This pump has no internal check valve (fuel can drain back to the tank when turned off) or anti-siphon valve (fuel can be pulled through the pump when turned off). Minimum dry lift capacity 12 inches. The positive and negative wires have a 2-pin Packard connector (Weather Pack "shroud") installed from the factory. Facet part number 40229, John Deere part number KV13829.
Beware of counterfeits! We only sell Genuine Facet pumps - not the unreliable foreign knock-offs sold elsewhere.
Not sure if this is the pump you need? Check out our article on Finding the Part Number on Facet Fuel Pumps.
