Brand: Beta Tools
| This item qualifies for FREE Shipping in the continental United States! |
Don't take a chance on damaging an expensive alternator trying to remove or install a clutch-type pulley (OAP or OAD) with an impact gun! Do the job right by using the proper tools.
The 1489 Series from Beta Tools are designed specifically to fit the drive types used on modern free-spin alternator pulleys. This complete kit includes a total of 14 tools in a fitted organizer case. The tools will help you remove and install pulleys on alternators from Bosch, Valeo, Nippondenso, Magnetti Marelli, and more. The kit even includes special wrenches to hold the outer pulley shaft portion of the tool stationary (for OAD pulleys) or to turn the pulley (OAP pulleys).
Kit includes:
867PE/8 - Bit, 10mm hex shank x 8mm male hex drive
867PE/L-8 - Bit, 10mm long hex shank x 8mm male hex drive
867XZN/L-10 - Bit, 10mm long hex shank x 10mm XZN® (triple square) drive
867/2 - Bit holder, 10mm hex bit to 1/2" square drive
920B/10 - Socket, 10mm 12-point female, 1/2" square drive
1489/31T - Assembly, 31 spline drive, 15mm hex outer sleeve + T50 Torx drive x 1/2" square drive inner
1489/33P - Assembly, 31 spline drive, 15mm hex outer sleeve + M10 XZN drive x 1/2" square drive inner (Fiat Grande Punto)
1489/33 - Sleeve, 49/64" x 33 spline drive, 15mm outer hex, 12mm ID
1489/E - Assembly, 15mm hex outer sleeve + 10mm female hex inner
1489R - Sleeve, 15mm male hex x 28mm male hex
1489/Y - Sleeve, 32mm male hex x 3-pin drive (Nippondenso)
188/10 - Ratcheting wrench for holding pulley shafts, 10mm
188/15 - Ratcheting wrench for holding pulley shafts, 15mm
Note: For use with hand tools only! Using impact wrenches with these tools will damage them and may cause injury. Using impact tools will void the warranty.
