Brand: Cartek Automotive Electronics Ltd
This connector set lets you assemble your own custom harness for your Cartek 16-Channel Power Distribution Panel, Part No. 1068-151 (sold separately).
Includes both AMP connectors plus 50 crimp-on terminal pins. Each terminals can accept 20 AWG to 16 AWG wire.* Wire is not included.
We also offer a partially-assembled Cartek Power Distribution Panel Pigtail Wiring Kit (Part No. 1068-152) which eliminates the need for crimping wires into the AMP terminals.
* According to Cartek, the very low-amp ECU Inputs / Switch Inputs / Switch Outputs / XR Signal Inputs can use 22-24 AWG wire, but the stripped end must be doubled over inside the terminal to provide a reliable crimp. We strongly recommend the use of 20 AWG wire that these terminals were designed for instead.
