Brand: SuperTrapp Industries
SuperTrapp mufflers are the only USDA Forest Service Approved spark arrestors that do not rely on restrictive swirl baffles or fragile screens. Sparks are funnelled into a collection chamber in the end cap, while exhaust gases exit between special diffuser discs. Even if the collection chamber filled to capacity, the small 0.023" gap between the discs still provides a back-up layer of spark protection.
The 3" diameter SuperTrapp 3S Series muffler is recommended for engines up to 10 HP, but it can also be used on engines up to 50 HP where compact size is a greater concern than noise reduction. The 3S can also be installed after a conventional muffler in installations where maximum muffling is required. In fact, it can be tuned so quietly that mechanical engine noise may drown out the exhaust note!
This kit includes a clamp-on flange to fit over a 1 1/8" diameter exhaust pipe, clamp, end cap with collection chamber, and center retaining bolt.
Requires diffuser discs, sold separately:
3-Pack of 3 inch Diffuser Discs (Part No. ST-3S-6503)
12-Pack of 3 inch Diffuser Discs (Part No. ST-3S-6512)
Typical installations should use 1 disc per 3 horsepower for proper back pressure (e.g., a 10 HP engine should use 3 discs). Using fewer discs will further reduce noise but will also cause some power loss. More discs should be used on engines rated below 2400 rpm, or if the 3S will be used in conjunction with an existing muffler.
