Brand: Campbell Motorsport
If you spend too much time trying to bed your brake pads, consider replacing your worn, grooved rotors! Our brake rotors are brand-new castings made in the USA exclusively for racing use. They are not repackaged street car rotors. Sold individually.
This size fits the front and rear of 1987 and newer Reynard FC with the standard LD19 calipers. The original Reynard rotor was a lightened and grooved version of this rotor (Part No. 3545-32).
| OD | Height | Thickness | ID | Bolt Pattern |
|---|
| 9.84" | 1.60" | 0.29" | 2.50" | (4) 3/8" on 3.75" circle |
*Height is measured from the inner friction surface to the outer face of the hat. Place the rotor down on a table and measure from the table surface to the highest point on the hat.
Note: Some of these cars have been converted to the larger LD20 caliper. Most of those cars still use this rotor, as there is no readily-available 10" rotor for the Reynard. The caliper must be shimmed to keep the rotor aligned with the caliper.
